Tag Archives: Quality Targets

Five 4 Inch Round Hangers 3/8″ AR500 NRA Action Pistol Plates (FREE SHIPPING!) Review

This fits your .

Make sure this fits by entering your model number.

Five Piece Set
4 Inch Diameter
3/8 Inch Thick
AR500 Steel

Five 4 in. Round NRA Hanging Targets

3/8 in.Thick AR500 – 5 Piece Set – With 3/8″ Mounting Hole

Product Information This is for five 4 in. round target with a 3/8″ diameter hole for mounting AR500 steel painted white Bolt to a wooden frame, hang on pins to be knocked off, many other ways to hang / use them. We have added a newer laser to our cutting table for better precision and less waste.

We ship same day as ordered.

Please email or contact us a 618-245-6515 with questions.

Also visit us at qualitytargets.com International Orders please feel free to contact us. Contact use for different diameters, quantities and thicknesses

Please Be Sure To Check Out Our Other Auctions!

Warnings

Please note: Shooter and all spectators must wear safety glasses in case of flying spatter. It is required that shooters wear appropriate hearing protection. Discontinue use if target becomes damaged.

Disclaimer:

Buyer assumes all responsibility for the use and misuse of the targets purchased.

NRA Steel Knockover Plates Six 8” Round Action Pistol Target Review

This fits your .

Make sure this fits by entering your model number.

8” Round Falling Plate
Set of six 8” round targets
2” x 4” pads
For lead target rounds, no hot factory or mag loads. Not for .223 rifle etc. We can make these out of AR500 (Very Hard Steel) but they will cost more.
A36 steel (Mild Steel) 3/8 in. thick

NRA Steel Knockover Plates Six 6” Round Action Pistol Target Review

This fits your .

Make sure this fits by entering your model number.

Six Knockover Action Pistol Targets
6” Diameter
For lead target rounds, no hot factory or mag loads. Not for .223 rifle etc. We can make these out of AR500 (Very Hard Steel) but they will cost more.
A36 Steel Mild Steel 3/8 In. Thick

Set of six 6” round targets on 2” x 4” pads.

Picture is of 8″ but they will look the same but smaller.

Targets round face is cut with a flat spot where it contacts the base so you get a much longer stronger weld.

Notice much longer weld.

Targets are manufactured per NRA specifications.

Plates are constructed of new 3/8 in. thick A36 steel

Shipped Via USPS Priority Mail – We ship same day as order is placed.

STEEL TARGETS: SAFETY AND USE From the FBI Training Bulletin There are many steel targets on the market allowing for a wide range of firearms training techniques. However, many of these targets do not provide adequate protection from bullet splatter so accidents can occur. It is important that the user know what factors make training on steel targets as safe and effective as possible.

When shooting steel targets, a “splatter zone” appears. This zone is the area in which the great majority of bullet fragments eventually wind up. The total amount of splatter in this zone is primarily dependent on the following four key issues: 1) Angle of deflection, 2) Bullet design and 3) Target placement.

Warnings

Please note: This target silhouettes are not for use with center fire rifles or shotgun slugs. Do not shoot steel targets from closer than 15 yards. Shooter and all spectators must wear safety glasses in case of flying spatter. It is required that shooters wear appropriate hearing protection. Discontinue use if target becomes damaged.

Disclaimer: Buyer assumes all responsibility for the use and misuse of the targets purchased.